The Flagship - 208 Concepts R&D daily driver
2014 F150 Ecoboost, nicknamed "The Mistress" 2.0:
Mods include:
208 Concepts V-band turbo adapters
208 Concepts equal length downpipes
208 Concepts VTA mount and blaster trumpet
S&B cold air intake
Used (and repaired) Mishimoto intercooler
SPD stage 1 resonator
Ford "Saudi Raptor" transmission cooler
CVF hot side charge pipes
XDI 35% high pressure pump
TIP-swapped 3-bar MAP sensor
2018 F150 Sport wheels
Spicer diff cover
Amazon special catch can (passenger side)
208 Concepts CAN-Flex system (Utilizing the Burger Motorsports CAN-ECA)
Upcoming mods:
208 Concepts built "stage2+" 6r80 transmission
Low pressure pump (still deciding which one)
208 Concepts inlet pipes
Comments
Related Products
3.5 Ecoboost V-band flanges (pair)
Ever try to remove your downpipes, only to snap the stud off in the turbo? It's a surefire way to ruin one's garage session! These flanges eliminate the factory hardware in favor of a clamp and flange, in addition to exposing more turbine to the exha
$180.00 Tax $180.00
Ford Ecoboost 3.5 Tuning
Unleash your 3.5 with a custom tune! Gains of 60 wheel horsepower or more is commonplace, along with a bump in MPG (around 2 on average). From mild street tunes, to wild combinations. All tunes take advantage of Fords adaptive octane behaviour. I
$350.00 Tax $350.00
Ecoboost equal length downpipes
Would you like the ultimate in clean exhaust sound for your 2.7 or 3.5 Ecoboost? V-band or OE style socket, and length matched from side to side, smoothing out the exhaust frequencies for a consistent sound.
$1,200.00 Tax $1,200.00
Ecoboost VTA Blaster
Are you running with the well known "VTA mod" and want a different tone from your truck? This 3D printed trumpet increases the pitch and volume to more audible levels without being ear splitting.
$25.00 Tax $25.00
6R80 center support bushing
Have a 6R80 and want to replace the center support with a reinforced part? Look no further than 208 Concepts! Virgin and used center supports (mail-in) available. Sonnax bushing modification available upon request.
$100.00 Tax $100.00
Ford 6R/ZF 6HP roller bearing conversion
Are you building a 6R80/6HP with the bushing style pump and want to upgrade to a needle bearing? We do that! Using the Alto brand needle bearing, I'll machine your pump (Or a replacement) to exacting tolerances, perfectly concentric to the seal bore.
$200.00 Tax $200.00